Home › Code lookup › P2712
Powertrain code · Transmission

P2712 Hydraulic Power Unit Leakage

How urgent? Get it checked in the next few days

What it means

The hydraulic unit that operates an automated or dual-clutch transmission is losing pressure, as if it has a leak.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the hydraulic fluid level and look for leaks
  2. Check system pressure with a scan tool

Signs you may notice

  • Check engine or transmission light on
  • Slow or failed gear changes
  • Car may not move or may not select a gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFluid leak from the hydraulic unit or lines
  • CommonWorn hydraulic pump or accumulator
  • PossibleLow hydraulic fluid
  • PossibleFaulty pressure sensor

Typical repair once the cause is confirmed

Repair the leak or replace the hydraulic unit or accumulator.

Walk through it step by step: Car won't go into gear →

Common questions

What does P2712 mean?

The hydraulic unit that operates an automated or dual-clutch transmission is losing pressure, as if it has a leak.

Can I drive with code P2712?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2712?

Common possibilities to test include: fluid leak from the hydraulic unit or lines; worn hydraulic pump or accumulator; low hydraulic fluid; faulty pressure sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.