Home › Code lookup › P2713
Powertrain code · Transmission

P2713 Pressure Control Solenoid "D"

How urgent? Get it checked in the next few days

What it means

The computer is watching the pressure control solenoid "D" and has spotted an electrical fault. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the pressure control solenoid "D", checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine or transmission warning light on
  • Harsh, late or erratic shifts
  • Transmission may go into limp mode (stuck in one gear)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the pressure control solenoid "D"
  • CommonBroken or chafed wire in the pressure control solenoid "D" circuit
  • CommonFailed pressure control solenoid "D"
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the pressure control solenoid "D".

Walk through it step by step: Transmission warning light on →

Common questions

What does P2713 mean?

The computer is watching the pressure control solenoid "D" and has spotted an electrical fault. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.

Can I drive with code P2713?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2713?

Common possibilities to test include: unplugged, loose or corroded connector at the pressure control solenoid "d"; broken or chafed wire in the pressure control solenoid "d" circuit; failed pressure control solenoid "d"; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.