P2733 Pressure Control Solenoid "F" Stuck On
What it means
The computer thinks the pressure control solenoid "F" is stuck on. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the transmission fluid level and condition
- Look for other transmission codes
- Have the solenoid tested and commanded with a scan tool
Signs you may notice
- Check engine or transmission warning light on
- Harsh, late or erratic shifts
- Transmission may go into limp mode (stuck in one gear)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSticking pressure control solenoid "F"
- CommonLow, dirty or wrong transmission fluid
- PossibleWorn valve body or internal fluid leak
- PossibleWorn clutches inside the transmission
Typical repair once the cause is confirmed
Service the fluid if it is low or dirty; if the code returns, replace pressure control solenoid "F" or the valve body it sits in.
Common questions
What does P2733 mean?
The computer thinks the pressure control solenoid "F" is stuck on. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.
Can I drive with code P2733?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2733?
Common possibilities to test include: sticking pressure control solenoid "f"; low, dirty or wrong transmission fluid; worn valve body or internal fluid leak; worn clutches inside the transmission. A shop should confirm the cause before replacing parts.