P2743 Transmission Fluid Temperature Sensor "B" Circuit High
What it means
The computer is watching the transmission fluid temperature sensor "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The transmission computer uses fluid temperature to adjust shift feel and torque converter lock-up.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the transmission fluid temperature sensor "B" circuit
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Shifts may feel firm or delayed
- Torque converter may not lock up
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to voltage or a broken ground wire
- CommonFailed transmission fluid temperature sensor "B"
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the transmission fluid temperature sensor "B".
Common questions
What does P2743 mean?
The computer is watching the transmission fluid temperature sensor "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The transmission computer uses fluid temperature to adjust shift feel and torque converter lock-up.
Can I drive with code P2743?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2743?
Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed transmission fluid temperature sensor "b"; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.