P2744 Transmission Fluid Temperature Sensor "B" Circuit Intermittent
What it means
The computer is watching the transmission fluid temperature sensor "B" circuit and is seeing a signal that cuts in and out. The transmission computer uses fluid temperature to adjust shift feel and torque converter lock-up.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the wiring for the transmission fluid temperature sensor "B" circuit with the engine running while watching live data
- Check connector pins for corrosion or spread terminals
- Note when it happens (hot, cold, bumps) to narrow it down
Signs you may notice
- Check engine light on
- Shifts may feel firm or delayed
- Torque converter may not lock up
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose connector or chafed wire that loses contact over bumps
- CommonTransmission fluid temperature sensor "B" failing on and off
- PossibleCorrosion inside the connector
- PossiblePoor ground connection
Typical repair once the cause is confirmed
Repair the loose or corroded connection; replace the transmission fluid temperature sensor "B" if the wiring is solid.
Common questions
What does P2744 mean?
The computer is watching the transmission fluid temperature sensor "B" circuit and is seeing a signal that cuts in and out. The transmission computer uses fluid temperature to adjust shift feel and torque converter lock-up.
Can I drive with code P2744?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2744?
Common possibilities to test include: loose connector or chafed wire that loses contact over bumps; transmission fluid temperature sensor "b" failing on and off; corrosion inside the connector; poor ground connection. A shop should confirm the cause before replacing parts.