Home › Code lookup › P2749
Powertrain code · Transmission

P2749 Intermediate Shaft Speed Sensor "C" Circuit

How urgent? Get it checked in the next few days

What it means

The computer is watching the intermediate shaft speed sensor "C" circuit and has spotted an electrical fault. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the intermediate shaft speed sensor "C" circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine or transmission light on
  • Harsh or erratic shifts
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the intermediate shaft speed sensor "C"
  • CommonBroken or chafed wire in the intermediate shaft speed sensor "C" circuit
  • CommonFailed intermediate shaft speed sensor "C"
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the intermediate shaft speed sensor "C".

Walk through it step by step: Harsh or late shifting →

Common questions

What does P2749 mean?

The computer is watching the intermediate shaft speed sensor "C" circuit and has spotted an electrical fault. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.

Can I drive with code P2749?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2749?

Common possibilities to test include: unplugged, loose or corroded connector at the intermediate shaft speed sensor "c"; broken or chafed wire in the intermediate shaft speed sensor "c" circuit; failed intermediate shaft speed sensor "c"; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.