Home › Code lookup › P2750
Powertrain code · Transmission

P2750 Intermediate Shaft Speed Sensor "C" Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The computer is watching the intermediate shaft speed sensor "C" circuit and is getting a signal that does not make sense for current conditions. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other codes that point to the underlying problem
  2. Compare the intermediate shaft speed sensor "C" circuit reading with expected values in live data
  3. Inspect the wiring and connector

Signs you may notice

  • Check engine or transmission light on
  • Harsh or erratic shifts
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing or sticking intermediate shaft speed sensor "C"
  • CommonSlipping clutches inside the transmission
  • PossibleWiring or connector with high resistance
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Find out whether the intermediate shaft speed sensor "C" itself or the system it works with is at fault, then repair or replace as needed.

Walk through it step by step: Harsh or late shifting →

Common questions

What does P2750 mean?

The computer is watching the intermediate shaft speed sensor "C" circuit and is getting a signal that does not make sense for current conditions. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.

Can I drive with code P2750?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2750?

Common possibilities to test include: failing or sticking intermediate shaft speed sensor "c"; slipping clutches inside the transmission; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.