P2752 Intermediate Shaft Speed Sensor "C" Circuit Intermittent
What it means
The computer is watching the intermediate shaft speed sensor "C" circuit and is seeing a signal that cuts in and out. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Wiggle the wiring for the intermediate shaft speed sensor "C" circuit with the engine running while watching live data
- Check connector pins for corrosion or spread terminals
- Note when it happens (hot, cold, bumps) to narrow it down
Signs you may notice
- Check engine or transmission light on
- Harsh or erratic shifts
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLoose connector or chafed wire that loses contact over bumps
- CommonIntermediate shaft speed sensor "C" failing on and off
- PossibleCorrosion inside the connector
- PossiblePoor ground connection
Typical repair once the cause is confirmed
Repair the loose or corroded connection; replace the intermediate shaft speed sensor "C" if the wiring is solid.
Common questions
What does P2752 mean?
The computer is watching the intermediate shaft speed sensor "C" circuit and is seeing a signal that cuts in and out. This sensor measures the speed of a shaft inside the transmission so the computer can time shifts.
Can I drive with code P2752?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2752?
Common possibilities to test include: loose connector or chafed wire that loses contact over bumps; intermediate shaft speed sensor "c" failing on and off; corrosion inside the connector; poor ground connection. A shop should confirm the cause before replacing parts.