Home › Code lookup › P2757
Powertrain code · Transmission

P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance/Stuck Off

How urgent? Get it checked in the next few days

What it means

The torque converter clutch pressure control solenoid circuit is not responding the way the computer expects. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the transmission fluid level and condition
  2. Look for other transmission codes
  3. Have the solenoid tested and commanded with a scan tool

Signs you may notice

  • Check engine light on
  • Shudder or vibration at steady speeds
  • Engine rpm higher than normal at highway speed
  • Lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking torque converter clutch solenoid
  • CommonLow, dirty or wrong transmission fluid
  • PossibleWorn torque converter clutch
  • PossibleWorn valve body

Typical repair once the cause is confirmed

Service the fluid first; if it returns, replace the solenoid, and in some cases the torque converter.

Walk through it step by step: Transmission warning light on →

Common questions

What does P2757 mean?

The torque converter clutch pressure control solenoid circuit is not responding the way the computer expects. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I drive with code P2757?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2757?

Common possibilities to test include: sticking torque converter clutch solenoid; low, dirty or wrong transmission fluid; worn torque converter clutch; worn valve body. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.