Home › Code lookup › P2758
Powertrain code · Transmission

P2758 Torque Converter Clutch Pressure Control Solenoid Control Circuit Stuck On

How urgent? Stop driving as soon as it's safe. This can cause damage or be unsafe.

What it means

The computer thinks the torque converter clutch pressure control solenoid circuit is stuck on. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I keep driving?

Be careful. If the converter stays locked, the engine can stall when you stop, leaving you with heavy steering and harder braking. If it stalls or nearly stalls, don't keep driving; have it towed. If it only shudders, limit driving and get it checked soon.

What to test before replacing parts

Confirm with a scanner whether lockup stays applied at stops, check the solenoid and its wiring for a short, and check the fluid and valve body before replacing the converter.

  1. Check the transmission fluid level and condition
  2. Look for other transmission codes
  3. Have the solenoid tested and commanded with a scan tool

Signs you may notice

  • Check engine light on
  • Shudder or vibration at steady speeds
  • Engine rpm higher than normal at highway speed
  • Lower fuel economy
  • Engine may stall when coming to a stop

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking torque converter clutch solenoid
  • CommonLow, dirty or wrong transmission fluid
  • PossibleWorn torque converter clutch
  • PossibleWorn valve body

Typical repair once the cause is confirmed

Service the fluid first; if it returns, replace the solenoid, and in some cases the torque converter.

Walk through it step by step: Transmission warning light on →

Common questions

What does P2758 mean?

The computer thinks the torque converter clutch pressure control solenoid circuit is stuck on. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I drive with code P2758?

Be careful. If the converter stays locked, the engine can stall when you stop, leaving you with heavy steering and harder braking. If it stalls or nearly stalls, don't keep driving; have it towed. If it only shudders, limit driving and get it checked soon.

What causes P2758?

Common possibilities to test include: sticking torque converter clutch solenoid; low, dirty or wrong transmission fluid; worn torque converter clutch; worn valve body. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.