P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical
What it means
The computer is watching the torque converter clutch pressure control solenoid circuit and has an electrical fault. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the torque converter clutch pressure control solenoid circuit, checking for damage, corrosion or a loose fit
- Check power, ground and resistance of the part with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- Shudder or vibration at steady speeds
- Engine rpm higher than normal at highway speed
- Lower fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the torque converter clutch pressure control solenoid
- CommonBroken or chafed wire in the torque converter clutch pressure control solenoid circuit
- CommonFailed torque converter clutch pressure control solenoid
- PossibleBlown fuse or failed relay feeding the circuit
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the torque converter clutch pressure control solenoid.
Common questions
What does P2759 mean?
The computer is watching the torque converter clutch pressure control solenoid circuit and has an electrical fault. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.
Can I drive with code P2759?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2759?
Common possibilities to test include: unplugged, loose or corroded connector at the torque converter clutch pressure control solenoid; broken or chafed wire in the torque converter clutch pressure control solenoid circuit; failed torque converter clutch pressure control solenoid; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.