Home › Code lookup › P2760
Powertrain code · Transmission

P2760 Torque Converter Clutch Pressure Control Solenoid Control Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The computer is watching the torque converter clutch pressure control solenoid circuit and is seeing a signal that cuts in and out. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the wiring for the torque converter clutch pressure control solenoid circuit with the engine running while watching live data
  2. Check connector pins for corrosion or spread terminals
  3. Note when it happens (hot, cold, bumps) to narrow it down

Signs you may notice

  • Check engine light on
  • Shudder or vibration at steady speeds
  • Engine rpm higher than normal at highway speed
  • Lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose connector or chafed wire that loses contact over bumps
  • CommonTorque converter clutch pressure control solenoid failing on and off
  • PossibleCorrosion inside the connector
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Repair the loose or corroded connection; replace the torque converter clutch pressure control solenoid if the wiring is solid.

Walk through it step by step: Transmission warning light on →

Common questions

What does P2760 mean?

The computer is watching the torque converter clutch pressure control solenoid circuit and is seeing a signal that cuts in and out. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.

Can I drive with code P2760?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2760?

Common possibilities to test include: loose connector or chafed wire that loses contact over bumps; torque converter clutch pressure control solenoid failing on and off; corrosion inside the connector; poor ground connection. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.