P2762 Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance
What it means
The computer is watching the torque converter clutch pressure control solenoid circuit and is getting a signal that does not make sense for current conditions. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other codes that point to the underlying problem
- Compare the torque converter clutch pressure control solenoid circuit reading with expected values in live data
- Inspect the wiring and connector
Signs you may notice
- Check engine light on
- Shudder or vibration at steady speeds
- Engine rpm higher than normal at highway speed
- Lower fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or sticking torque converter clutch pressure control solenoid
- CommonA real problem in the system the part works with
- PossibleWiring or connector with high resistance
- PossibleComputer software that needs an update
Typical repair once the cause is confirmed
Find out whether the torque converter clutch pressure control solenoid itself or the system it works with is at fault, then repair or replace as needed.
Common questions
What does P2762 mean?
The computer is watching the torque converter clutch pressure control solenoid circuit and is getting a signal that does not make sense for current conditions. This solenoid controls the lock-up clutch in the torque converter, which links the engine directly to the transmission at cruising speed.
Can I drive with code P2762?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2762?
Common possibilities to test include: failing or sticking torque converter clutch pressure control solenoid; a real problem in the system the part works with; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.