P2767 Input/Turbine Speed Sensor "B" Circuit No Signal
What it means
The computer is watching the input/turbine speed sensor "B" circuit and is not getting any signal at all. This sensor measures how fast the transmission input is turning so the computer can control shifts and lock-up.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the input/turbine speed sensor "B" circuit, checking for damage, corrosion or a loose fit
- Check power, ground and signal with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine or transmission light on
- Harsh or erratic shifts
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the input/turbine speed sensor "B"
- CommonBroken or chafed wire in the input/turbine speed sensor "B" circuit
- CommonFailed input/turbine speed sensor "B"
- PossibleMissing reference voltage or ground from the computer
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the input/turbine speed sensor "B".
Known on these vehicles
Common questions
What does P2767 mean?
The computer is watching the input/turbine speed sensor "B" circuit and is not getting any signal at all. This sensor measures how fast the transmission input is turning so the computer can control shifts and lock-up.
Can I drive with code P2767?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2767?
Common possibilities to test include: unplugged, loose or corroded connector at the input/turbine speed sensor "b"; broken or chafed wire in the input/turbine speed sensor "b" circuit; failed input/turbine speed sensor "b"; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.