Home › Code lookup › P2769
Powertrain code · Transmission

P2769 Torque Converter Clutch Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the torque converter clutch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The lock-up clutch links the engine directly to the transmission at cruising speed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the torque converter clutch circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Shudder or vibration at steady speeds
  • Engine rpm higher than normal at highway speed
  • Lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the torque converter clutch solenoid shorted to ground
  • CommonFailed torque converter clutch solenoid
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the torque converter clutch solenoid.

Walk through it step by step: Transmission warning light on →

Common questions

What does P2769 mean?

The computer is watching the torque converter clutch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The lock-up clutch links the engine directly to the transmission at cruising speed.

Can I drive with code P2769?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2769?

Common possibilities to test include: control wire to the torque converter clutch solenoid shorted to ground; failed torque converter clutch solenoid; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.