Home › Code lookup › P2773
Powertrain code · Transmission

P2773 Four Wheel Drive (4WD) Low Switch Circuit Low

How urgent? Book a check when convenient

What it means

The computer is watching the 4WD low switch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The computer uses this switch to know when four-wheel-drive low range is selected.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the 4WD low switch circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine or 4WD light on
  • 4WD low may not engage or indicate correctly
  • Shift timing may be off in 4WD low

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the 4WD low switch circuit shorted to ground or open
  • CommonFailed 4WD low range switch
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the 4WD low range switch.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P2773 mean?

The computer is watching the 4WD low switch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The computer uses this switch to know when four-wheel-drive low range is selected.

Can I drive with code P2773?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2773?

Common possibilities to test include: signal wire in the 4wd low switch circuit shorted to ground or open; failed 4wd low range switch; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.