Home › Code lookup › P2777
Powertrain code · Transmission

P2777 Upshift Switch Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the upshift switch circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This switch lets you shift up manually with a paddle or the shift lever.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the upshift switch circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Manual shift buttons or paddles may not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or sticking switch, sometimes from spilled drinks in the shifter
  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed upshift switch (paddle or shifter button)
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the upshift switch (paddle or shifter button).

Walk through it step by step: Transmission warning light on →

Common questions

What does P2777 mean?

The computer is watching the upshift switch circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This switch lets you shift up manually with a paddle or the shift lever.

Can I drive with code P2777?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2777?

Common possibilities to test include: worn or sticking switch, sometimes from spilled drinks in the shifter; signal wire shorted to voltage or a broken ground wire; failed upshift switch (paddle or shifter button); corroded or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.