Home › Code lookup › P2782
Powertrain code · Transmission

P2782 Downshift Switch Circuit Intermittent/Erratic

How urgent? Book a check when convenient

What it means

The computer is watching the downshift switch circuit and is seeing a signal that cuts in and out. This switch lets you shift down manually with a paddle or the shift lever.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the wiring for the downshift switch circuit with the engine running while watching live data
  2. Check connector pins for corrosion or spread terminals
  3. Note when it happens (hot, cold, bumps) to narrow it down

Signs you may notice

  • Check engine light on
  • Manual shift buttons or paddles may not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or sticking switch, sometimes from spilled drinks in the shifter
  • CommonLoose connector or chafed wire that loses contact over bumps
  • CommonDownshift switch (paddle or shifter button) failing on and off
  • PossibleCorrosion inside the connector
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Repair the loose or corroded connection; replace the downshift switch (paddle or shifter button) if the wiring is solid.

Walk through it step by step: Transmission warning light on →

Common questions

What does P2782 mean?

The computer is watching the downshift switch circuit and is seeing a signal that cuts in and out. This switch lets you shift down manually with a paddle or the shift lever.

Can I drive with code P2782?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2782?

Common possibilities to test include: worn or sticking switch, sometimes from spilled drinks in the shifter; loose connector or chafed wire that loses contact over bumps; downshift switch (paddle or shifter button) failing on and off; corrosion inside the connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.