Home › Code lookup › P278A
Powertrain code · Transmission

P278A Kick Down Switch Circuit

How urgent? Book a check when convenient

What it means

The computer is watching the kickdown switch circuit and has spotted an electrical fault. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the kickdown switch circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • No quick downshift when flooring the pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the kickdown switch
  • CommonBroken or chafed wire in the kickdown switch circuit
  • CommonFailed kickdown switch
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the kickdown switch.

Walk through it step by step: Transmission warning light on →

Common questions

What does P278A mean?

The computer is watching the kickdown switch circuit and has spotted an electrical fault. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I drive with code P278A?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P278A?

Common possibilities to test include: unplugged, loose or corroded connector at the kickdown switch; broken or chafed wire in the kickdown switch circuit; failed kickdown switch; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.