Home › Code lookup › P278C
Powertrain code · Transmission

P278C Kick Down Switch Circuit Low

How urgent? Book a check when convenient

What it means

The computer is watching the kickdown switch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the kickdown switch circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • No quick downshift when flooring the pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the kickdown switch circuit shorted to ground or open
  • CommonFailed kickdown switch
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the kickdown switch.

Walk through it step by step: Transmission warning light on →

Common questions

What does P278C mean?

The computer is watching the kickdown switch circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I drive with code P278C?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P278C?

Common possibilities to test include: signal wire in the kickdown switch circuit shorted to ground or open; failed kickdown switch; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.