Home › Code lookup › P278D
Powertrain code · Transmission

P278D Kick Down Switch Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the kickdown switch circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the kickdown switch circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • No quick downshift when flooring the pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed kickdown switch
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the kickdown switch.

Walk through it step by step: Transmission warning light on →

Common questions

What does P278D mean?

The computer is watching the kickdown switch circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I drive with code P278D?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P278D?

Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed kickdown switch; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.