Home › Code lookup › P278E
Powertrain code · Transmission

P278E Kick Down Switch Circuit Intermittent/Erratic

How urgent? Book a check when convenient

What it means

The computer is watching the kickdown switch circuit and is seeing a signal that cuts in and out. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the wiring for the kickdown switch circuit with the engine running while watching live data
  2. Check connector pins for corrosion or spread terminals
  3. Note when it happens (hot, cold, bumps) to narrow it down

Signs you may notice

  • Check engine light on
  • No quick downshift when flooring the pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose connector or chafed wire that loses contact over bumps
  • CommonKickdown switch failing on and off
  • PossibleCorrosion inside the connector
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Repair the loose or corroded connection; replace the kickdown switch if the wiring is solid.

Walk through it step by step: Transmission warning light on →

Common questions

What does P278E mean?

The computer is watching the kickdown switch circuit and is seeing a signal that cuts in and out. This switch under or in the gas pedal tells the transmission you pushed the pedal to the floor and want a quick downshift.

Can I drive with code P278E?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P278E?

Common possibilities to test include: loose connector or chafed wire that loses contact over bumps; kickdown switch failing on and off; corrosion inside the connector; poor ground connection. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.