Home › Code lookup › P2793
Powertrain code · Transmission

P2793 Gear Shift Direction Circuit

How urgent? Get it checked in the next few days

What it means

The computer is watching the gear shift direction circuit and has spotted an electrical fault. On automated manual transmissions, this actuator moves the gear selector forward and back to engage gears.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the gear shift direction circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine or transmission light on
  • Gear changes may fail or be slow
  • Transmission may not select a gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the gear shift actuator
  • CommonBroken or chafed wire in the gear shift direction circuit
  • CommonFailed gear shift actuator
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the gear shift actuator.

Walk through it step by step: Car won't go into gear →

Common questions

What does P2793 mean?

The computer is watching the gear shift direction circuit and has spotted an electrical fault. On automated manual transmissions, this actuator moves the gear selector forward and back to engage gears.

Can I drive with code P2793?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2793?

Common possibilities to test include: unplugged, loose or corroded connector at the gear shift actuator; broken or chafed wire in the gear shift direction circuit; failed gear shift actuator; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.