Home › Code lookup › P2798
Powertrain code · Transmission

P2798 Auxiliary Transmission Fluid Pump Control Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the auxiliary transmission fluid pump control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Cars with engine stop-start or hybrid drive use an electric pump to keep the transmission ready while the engine is off.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the auxiliary transmission fluid pump control circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Engine auto stop-start may be disabled
  • Delayed or harsh engagement when pulling away

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the auxiliary transmission fluid pump shorted to ground
  • CommonFailed auxiliary transmission fluid pump
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the auxiliary transmission fluid pump.

Walk through it step by step: Delay engaging Drive or Reverse →

Common questions

What does P2798 mean?

The computer is watching the auxiliary transmission fluid pump control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Cars with engine stop-start or hybrid drive use an electric pump to keep the transmission ready while the engine is off.

Can I drive with code P2798?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2798?

Common possibilities to test include: control wire to the auxiliary transmission fluid pump shorted to ground; failed auxiliary transmission fluid pump; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.