Home › Code lookup › P279A
Powertrain code · Transmission

P279A Transfer Case Gear High Incorrect Ratio

How urgent? Get it checked in the next few days

What it means

The transfer case is in high range, but the speed sensors show a gear ratio that does not match.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the transfer case fluid
  2. Make sure all four tires are the same size
  3. Check speed sensor readings in live data

Signs you may notice

  • Check engine or 4WD light on
  • 4WD may not engage or may slip
  • Grinding or clunking from the transfer case possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonTransfer case not fully shifted into range
  • CommonWorn transfer case chain or gears
  • PossibleLow or wrong transfer case fluid
  • PossibleFaulty speed sensor or mismatched tire sizes

Typical repair once the cause is confirmed

Repair the shift motor, worn parts or sensor causing the mismatch.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P279A mean?

The transfer case is in high range, but the speed sensors show a gear ratio that does not match.

Can I drive with code P279A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P279A?

Common possibilities to test include: transfer case not fully shifted into range; worn transfer case chain or gears; low or wrong transfer case fluid; faulty speed sensor or mismatched tire sizes. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.