Home › Code lookup › P279D
Powertrain code · Transmission

P279D Four Wheel Drive (4WD) Range Signal Circuit

How urgent? Book a check when convenient

What it means

The computer is watching the 4WD range signal circuit and has spotted an electrical fault. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the 4WD range signal circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine or 4WD light on
  • 4WD may not shift ranges or indicate correctly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the 4WD range sensor
  • CommonBroken or chafed wire in the 4WD range signal circuit
  • CommonFailed 4WD range sensor
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the 4WD range sensor.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P279D mean?

The computer is watching the 4WD range signal circuit and has spotted an electrical fault. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I drive with code P279D?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P279D?

Common possibilities to test include: unplugged, loose or corroded connector at the 4wd range sensor; broken or chafed wire in the 4wd range signal circuit; failed 4wd range sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.