Home › Code lookup › P279E
Powertrain code · Transmission

P279E Four Wheel Drive (4WD) Range Signal Circuit Range/Performance

How urgent? Book a check when convenient

What it means

The computer is watching the 4WD range signal circuit and is getting a signal that does not make sense for current conditions. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other codes that point to the underlying problem
  2. Compare the 4WD range signal circuit reading with expected values in live data
  3. Inspect the wiring and connector

Signs you may notice

  • Check engine or 4WD light on
  • 4WD may not shift ranges or indicate correctly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing or sticking 4WD range sensor
  • CommonA real problem in the system the part works with
  • PossibleWiring or connector with high resistance
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Find out whether the 4WD range sensor itself or the system it works with is at fault, then repair or replace as needed.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P279E mean?

The computer is watching the 4WD range signal circuit and is getting a signal that does not make sense for current conditions. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I drive with code P279E?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P279E?

Common possibilities to test include: failing or sticking 4wd range sensor; a real problem in the system the part works with; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.