Home › Code lookup › P279F
Powertrain code · Transmission

P279F Four Wheel Drive (4WD) Range Signal Circuit Low

How urgent? Book a check when convenient

What it means

The computer is watching the 4WD range signal circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the 4WD range signal circuit for rubbed-through insulation touching metal
  2. Unplug the 4WD range sensor and see if the reading changes
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine or 4WD light on
  • 4WD may not shift ranges or indicate correctly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the 4WD range signal circuit shorted to ground or open
  • CommonFailed 4WD range sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the 4WD range sensor.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P279F mean?

The computer is watching the 4WD range signal circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I drive with code P279F?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P279F?

Common possibilities to test include: signal wire in the 4wd range signal circuit shorted to ground or open; failed 4wd range sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.