Home › Code lookup › P27A0
Powertrain code · Transmission

P27A0 Four Wheel Drive (4WD) Range Signal Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the 4WD range signal circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the 4WD range signal circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine or 4WD light on
  • 4WD may not shift ranges or indicate correctly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed 4WD range sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the 4WD range sensor.

Walk through it step by step: 4WD or AWD not engaging →

Common questions

What does P27A0 mean?

The computer is watching the 4WD range signal circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This signal tells the computer which four-wheel-drive range (high, low or neutral) is selected.

Can I drive with code P27A0?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P27A0?

Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed 4wd range sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.