Home › Code lookup › U0100
Network code · Network

U0100 Lost Communication With ECM/PCM "A"

How urgent? Get it checked in the next few days

What it means

Other computers in the car have stopped hearing from the engine computer (ECM/PCM). It runs the engine, so other modules rely on it for engine speed, temperature and other data.

Can I keep driving?

Use care. If the engine stalls, won't start, or several warnings and gauges drop out, don't rely on the car; have it towed, since a stall in traffic is dangerous. If it runs normally with just a light on, get it to a shop soon.

What to test before replacing parts

Check the engine computer's power, grounds and fuses, battery voltage, and network wiring at its connector before replacing the engine computer.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the engine computer (ECM/PCM)
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Check engine light and several other warning lights on
  • Car may not start, or may stall
  • Gauges such as the tachometer may stop working
  • Transmission may stay in one gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonEngine computer lost power or ground (blown fuse, bad relay or corroded ground)
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed engine computer (ECM/PCM)
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the engine computer (ECM/PCM); replace the module only after those test good.

Repair costInsufficient verified pricing for this vehicle and repair
Repair engine computer power, ground or network wiring. Prepare an itemized shop request.

Where it shows up

  • Often set during a dead battery or jump start; clear and recheck after the battery is fixed

Known on these vehicles

Walk through it step by step: Car won't start →

Common questions

What does U0100 mean?

Other computers in the car have stopped hearing from the engine computer (ECM/PCM). It runs the engine, so other modules rely on it for engine speed, temperature and other data.

Can I drive with code U0100?

Use care. If the engine stalls, won't start, or several warnings and gauges drop out, don't rely on the car; have it towed, since a stall in traffic is dangerous. If it runs normally with just a light on, get it to a shop soon.

What causes U0100?

Common possibilities to test include: engine computer lost power or ground (blown fuse, bad relay or corroded ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed engine computer (ecm/pcm). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.