U0112 Lost Communication With Battery Energy Control Module "B"
What it means
Other computers in the car have stopped hearing from the second hybrid battery control module. It is part of the hybrid or electric drive system.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the second hybrid battery control module
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- Hybrid or EV system warning on
- Car may not go into Ready mode or may lose power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThe second hybrid battery control module lost power or ground (blown fuse or bad ground)
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed second hybrid battery control module
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the second hybrid battery control module; replace the module only after those test good.
Common questions
What does U0112 mean?
Other computers in the car have stopped hearing from the second hybrid battery control module. It is part of the hybrid or electric drive system.
Can I drive with code U0112?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0112?
Common possibilities to test include: the second hybrid battery control module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed second hybrid battery control module. A shop should confirm the cause before replacing parts.