Home › Code lookup › U0111
Network code · Network

U0111 Lost Communication With Battery Energy Control Module "A"

How urgent? Get it checked in the next few days

What it means

Other computers in the car have stopped hearing from the hybrid battery control module. It is part of the hybrid or electric drive system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the hybrid battery control module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Hybrid or EV system warning on
  • Car may not go into Ready mode or may lose power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonThe hybrid battery control module lost power or ground (blown fuse or bad ground)
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed hybrid battery control module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the hybrid battery control module; replace the module only after those test good.

Walk through it step by step: Check hybrid system warning →

Common questions

What does U0111 mean?

Other computers in the car have stopped hearing from the hybrid battery control module. It is part of the hybrid or electric drive system.

Can I drive with code U0111?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0111?

Common possibilities to test include: the hybrid battery control module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed hybrid battery control module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.