U0113 Lost Communication With Emissions Critical Control Information
What it means
Other computers in the car have stopped hearing from the emissions-related control data. It helps run part of the engine or drivetrain.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the emissions-related control data
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- Check engine light on
- Engine may run poorly, lose power or not start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThe emissions-related control data lost power or ground (blown fuse or bad ground)
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed emissions-related control data
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the emissions-related control data; replace the module only after those test good.
Common questions
What does U0113 mean?
Other computers in the car have stopped hearing from the emissions-related control data. It helps run part of the engine or drivetrain.
Can I drive with code U0113?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0113?
Common possibilities to test include: the emissions-related control data lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed emissions-related control data. A shop should confirm the cause before replacing parts.