Home › Code lookup › U0123
Network code · Network

U0123 Lost Communication With Yaw Rate Sensor Module

How urgent? Get it checked in the next few days

What it means

Other computers in the car have stopped hearing from the yaw rate sensor module. It is part of the anti-lock brake and stability control system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the yaw rate sensor module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • ABS, traction control or stability light on
  • ABS and stability control may be turned off
  • Normal braking usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWater in the ABS module connector or a corroded module
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed yaw rate sensor module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the yaw rate sensor module; replace the module only after those test good.

Walk through it step by step: ABS light on →

Common questions

What does U0123 mean?

Other computers in the car have stopped hearing from the yaw rate sensor module. It is part of the anti-lock brake and stability control system.

Can I drive with code U0123?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0123?

Common possibilities to test include: water in the abs module connector or a corroded module; damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed yaw rate sensor module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.