U0126 Lost Communication With Steering Angle Sensor Module
What it means
Other computers in the car have stopped hearing from the steering angle sensor module. It is part of the anti-lock brake and stability control system.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the steering angle sensor module
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- ABS, traction control or stability light on
- ABS and stability control may be turned off
- Normal braking usually still works
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWater in the ABS module connector or a corroded module
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed steering angle sensor module
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the steering angle sensor module; replace the module only after those test good.
Common questions
What does U0126 mean?
Other computers in the car have stopped hearing from the steering angle sensor module. It is part of the anti-lock brake and stability control system.
Can I drive with code U0126?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0126?
Common possibilities to test include: water in the abs module connector or a corroded module; damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed steering angle sensor module. A shop should confirm the cause before replacing parts.