U0132 Lost Communication With Suspension Control Module "A"
What it means
Other computers in the car have stopped hearing from the suspension control module. It controls part of the suspension or ride system.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the suspension control module
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- Suspension or chassis warning light on
- Ride height or firmness may change
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThe suspension control module lost power or ground (blown fuse or bad ground)
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed suspension control module
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the suspension control module; replace the module only after those test good.
Common questions
What does U0132 mean?
Other computers in the car have stopped hearing from the suspension control module. It controls part of the suspension or ride system.
Can I drive with code U0132?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes U0132?
Common possibilities to test include: the suspension control module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed suspension control module. A shop should confirm the cause before replacing parts.