Home › Code lookup › U0139
Network code · Network

U0139 Lost Communication With Suspension Control Module "B"

How urgent? Book a check when convenient

What it means

Other computers in the car have stopped hearing from the second suspension control module. It controls part of the suspension or ride system.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the second suspension control module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Suspension or chassis warning light on
  • Ride height or firmness may change

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonThe second suspension control module lost power or ground (blown fuse or bad ground)
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed second suspension control module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the second suspension control module; replace the module only after those test good.

Common questions

What does U0139 mean?

Other computers in the car have stopped hearing from the second suspension control module. It controls part of the suspension or ride system.

Can I drive with code U0139?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes U0139?

Common possibilities to test include: the second suspension control module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed second suspension control module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.