U0147 Lost Communication With Serial Data Gateway Module "B"
What it means
Other computers in the car have stopped hearing from the second network gateway module. It passes messages between the different networks in the car.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the second network gateway module
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- Many warning lights on at once
- Several modules may not respond to a scan tool
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThe second network gateway module lost power or ground (blown fuse or bad ground)
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed second network gateway module
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the second network gateway module; replace the module only after those test good.
Common questions
What does U0147 mean?
Other computers in the car have stopped hearing from the second network gateway module. It passes messages between the different networks in the car.
Can I drive with code U0147?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0147?
Common possibilities to test include: the second network gateway module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed second network gateway module. A shop should confirm the cause before replacing parts.