Home › Code lookup › U0151
Network code · Network

U0151 Lost Communication With Restraints Control Module

How urgent? Get it checked in the next few days

What it means

Other computers in the car have stopped hearing from the airbag control module. It is part of the airbag and seat belt safety system.

Can I keep driving?

The car will usually drive normally, but airbags and seat belt tensioners may not work in a crash. Get it checked soon and drive as little as you can until it's fixed.

What to test before replacing parts

Check airbag module power, ground and fuses, network wiring and connectors (often under the seats), and battery voltage before replacing the module, following airbag safety steps.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the airbag control module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Airbag warning light on
  • Airbags or seat belt tensioners may not work in a crash
  • Other modules may set related codes

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose connector under a seat or at the airbag module
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed airbag control module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the airbag control module; replace the module only after those test good.

Repair costInsufficient verified pricing for this vehicle and repair
Replace airbag control module. Prepare an itemized shop request.
Walk through it step by step: Airbag (SRS) light on →

Common questions

What does U0151 mean?

Other computers in the car have stopped hearing from the airbag control module. It is part of the airbag and seat belt safety system.

Can I drive with code U0151?

The car will usually drive normally, but airbags and seat belt tensioners may not work in a crash. Get it checked soon and drive as little as you can until it's fixed.

What causes U0151?

Common possibilities to test include: loose connector under a seat or at the airbag module; damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed airbag control module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.