U0168 Lost Communication With Vehicle Security Control Module
What it means
Other computers in the car have stopped hearing from the security module. It is part of the anti-theft system that checks the key before the engine can run.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage first
- Check the fuses, power and ground for the security module
- See which modules answer a scan tool to narrow down the break
- Inspect network wiring and connectors near the module
Signs you may notice
- Security light on or flashing
- Car may crank but not start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThe security module lost power or ground (blown fuse or bad ground)
- CommonDamaged, corroded or loose network wiring or connector
- CommonWeak battery or low system voltage
- PossibleFailed security module
- PossibleAnother module shorting out the network
Typical repair once the cause is confirmed
Restore power, ground or wiring to the security module; replace the module only after those test good.
Common questions
What does U0168 mean?
Other computers in the car have stopped hearing from the security module. It is part of the anti-theft system that checks the key before the engine can run.
Can I drive with code U0168?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0168?
Common possibilities to test include: the security module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed security module. A shop should confirm the cause before replacing parts.