Home › Code lookup › U0172
Network code · Network

U0172 Lost Communication With Restraints System Sensor "C"

How urgent? Get it checked in the next few days

What it means

Other computers in the car have stopped hearing from the airbag crash sensor "C". It is part of the airbag and seat belt safety system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the airbag crash sensor "C"
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Airbag warning light on
  • Airbags or seat belt tensioners may not work in a crash

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose connector under a seat or at the airbag module
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed airbag crash sensor "C"
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the airbag crash sensor "C"; replace the module only after those test good.

Walk through it step by step: Airbag (SRS) light on →

Common questions

What does U0172 mean?

Other computers in the car have stopped hearing from the airbag crash sensor "C". It is part of the airbag and seat belt safety system.

Can I drive with code U0172?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0172?

Common possibilities to test include: loose connector under a seat or at the airbag module; damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed airbag crash sensor "c". A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.