Your 2017 BMW 6 / 8 Seriesproblems, repair costs and recalls
What we've documented about the 2017 BMW 6 / 8 Series: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2017 BMW 6 / 8 Series
12 documented issues apply to 2017, most serious first.
Twin-turbo V8 burns oil from worn valve stem seals
- What you'll notice
- Blue smoke at startup or when slowing down, an oil smell, and the oil level dropping quickly.
- Why it happens
- On the 650i's N63 V8 the turbos sit between the cylinder banks, and that heat wears out valve stem seals early.
- What to do
- Check oil often. Ask whether BMW's Customer Care Package updates were done. Heavy smoking means the seals need replacing.
Turbochargers fail on the 650i
- What you'll notice
- Loss of power, a whining or siren noise, smoke, or oil in the intake.
- Why it happens
- The hot-V layout cooks the turbochargers and their oil lines, so they wear out sooner than on other engines.
- What to do
- Have boost and oil leaks checked at the first sign. Turbo replacement on this V8 is a big job.
High-pressure fuel pump fails
- What you'll notice
- Long cranking, rough idle, hesitation, misfires, or the engine dropping into reduced power.
- Why it happens
- The high-pressure pump that feeds the direct-injection system wears internally.
- What to do
- Have fuel pressure codes read. A failing pump is replaced; ask the dealer about any extended coverage.
Thermostat and plastic coolant pipes fail on the 640i
- What you'll notice
- The temperature gauge swings, coolant goes missing, or an overheating warning appears.
- Why it happens
- The electric thermostat and plastic coolant pipes on the N55 are weak points.
- What to do
- Stop if the engine overheats. Above about 80,000 miles many owners replace the cooling parts as a set.
Rod bearing wear on the M6
- What you'll notice
- Knocking at idle or under load.
- Why it happens
- The M6's S63 V8 rod bearings can wear early, especially on cars used on track.
- What to do
- Have oil analysis and a specialist inspection done. Preventive bearing replacement is common.
Seat side airbags may not deploy (recall)
- What you'll notice
- No warning. The problem only shows in a crash.
- Why it happens
- The igniters in the seat-mounted side airbags may not fire.
- What to do
- Check your VIN with BMW; the airbag modules are replaced free.
Free at a BMW dealer. Check your VIN to see if it was already done.
Convertible top stops or works slowly
- What you'll notice
- The soft top moves slowly, stops partway, won't latch, or won't open or close at all.
- Why it happens
- The top runs on a hydraulic pump and cylinders with small position switches. Pumps wear out, cylinder seals leak, and switches fail.
- What to do
- Test the top several times before buying. Have a specialist read the top codes before replacing big parts; a switch or leaking cylinder is often the cause.
Front control arm bushings wear and the wheel shakes when braking
- What you'll notice
- Clunks over bumps, a steering wheel shake when braking, loose steering, or uneven tire wear.
- Why it happens
- The front control arm bushings on these heavy coupes and convertibles crack and wear out with age and mileage.
- What to do
- Have the front suspension checked. New arms or bushings and an alignment usually fix it.
Fuel injectors fail on the 650i V8
- What you'll notice
- Rough running, misfires, a fuel smell, or a check engine light.
- Why it happens
- Deposits build on the injector tips, or the injectors fail electrically.
- What to do
- Get misfire codes diagnosed. Injectors are often replaced in sets.
Valve cover and oil separator leak on the 640i
- What you'll notice
- A burning oil smell and oily residue on top of the engine.
- Why it happens
- Heat cycles break down the valve cover gasket and the built-in crankcase vent system on the N55 engine.
- What to do
- Have it repaired before oil gets on the exhaust or ignition coils.
iDrive screen freezes, reboots or goes blank
- What you'll notice
- The center screen freezes, restarts by itself, goes black, or phones won't connect.
- Why it happens
- Early iDrive units in particular are known for software and hardware faults; later units are better but can still lock up.
- What to do
- Try a system reset and ask a dealer for the latest software. If the unit has failed, a used or later-version unit is often the fix.
Trunk seals leak and the carpet gets wet
- What you'll notice
- Wet carpet or water in the trunk.
- Why it happens
- The trunk seals are known to fail on this generation.
- What to do
- Have the seals replaced and dry the trunk out to prevent electrical damage.
Repair prices for your 2017 BMW 6 / 8 Series
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose and update or replace iDrive head unit
- Repair convertible top hydraulic pump or cylinder
- Replace front control arms (pair) and align
- Replace valve stem seals (twin-turbo V8)
- Replace one turbocharger (rebuilt BMW unit)
- Replace high-pressure fuel pump
- Replace fuel injectors
- Replace valve cover with gasket
- Replace thermostat
- Replace trunk seal
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a BMW dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…