Your 1998 Chrysler Sebringproblems, repair costs and recalls
What we've documented about the 1998 Chrysler Sebring: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1998 Chrysler Sebring
5 documented issues apply to 1998, most serious first.
Automatic transmission failure
- What you'll notice
- Slipping, flaring revs between shifts, harsh shifts, or the car stuck in one gear or not moving.
- Why it happens
- The automatic transmission in this generation wears out, often around 90,000 miles.
- What to do
- Check the fluid level and condition. If it slips or will not move, get a transmission diagnosis before more damage is done.
Front lower ball joints can separate (recalls)
- What you'll notice
- Clunking from the front end, wandering steering, or uneven tire wear. In the worst case the wheel can fold under the car.
- Why it happens
- The rubber boots on the front lower ball joints can tear and let in water and dirt, so the joint wears or corrodes until it separates. Recalls 97V-201, 99V-066 and 00V-421 inspect and replace them.
- What to do
- Have a dealer check all three ball joint recalls by VIN, and have the front end inspected if you hear clunks.
Free at a Chrysler, Dodge, Jeep or Ram dealer if it was never done. Check your VIN.
Shifter can let the key come out when not in Park (recall)
- What you'll notice
- The key may come out of the ignition with the shifter not in Park, or the shifter feels loose.
- Why it happens
- A shifter cable adjustment problem can break a pin and defeat the park interlock. Recall 98V-183 replaces the shifter parts where needed.
- What to do
- Always set the parking brake. Have a dealer check the recall.
Free at a Chrysler, Dodge, Jeep or Ram dealer if it was never done. Check your VIN.
Stalling or no-start from a failed distributor sensor
- What you'll notice
- The engine stalls without warning, often once warm, or cranks but will not start. It may restart after cooling down.
- Why it happens
- A sensor built into the distributor that tells the computer engine position fails, so the engine loses spark and fuel.
- What to do
- Have a shop check for spark and position-sensor codes when it acts up. Replacing the distributor or its sensor usually fixes it.
Failed emissions test
- What you'll notice
- The check engine light is on, or the car fails a state smog or emissions test.
- Why it happens
- Worn oxygen sensors, catalytic converters and related parts on high-mileage cars are the usual cause.
- What to do
- Have the codes read before the test so you know which part is causing the failure.
Repair prices for your 1998 Chrysler Sebring
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transmission
- Replace distributor or pickup sensor
- Replace oxygen sensor or catalytic converter
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…