Your 2016 Dodge Viperproblems, repair costs and recalls
What we've documented about the 2016 Dodge Viper: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2016 Dodge Viper
8 documented issues apply to 2016, most serious first.
Passenger airbag door can break loose (recall)
- What you'll notice
- No symptoms. In a crash the passenger airbag door could detach.
- Why it happens
- A bad weld on the passenger airbag chute on cars built in early January 2016. Dealers replace the upper dash panel.
- What to do
- Ask a dealer to check recall 16V750000.
Free at a Dodge/Chrysler dealer if the recall was never done.
Driver airbag wiring can be pinched (recall)
- What you'll notice
- The airbag warning light may come on. The driver airbag may not deploy correctly.
- Why it happens
- Wiring for the driver airbag could be pinched on some 2016 cars. Dealers replace the airbag and clockspring.
- What to do
- Ask a dealer to check recall 16V736000.
Free at a Dodge/Chrysler dealer if the recall was never done.
Clutch slipping or wearing out
- What you'll notice
- Engine revs climb without the car speeding up, especially under hard acceleration, a burning smell after hard driving, or the engagement point moving around in the pedal travel.
- Why it happens
- The V10's huge torque is hard on the clutch, and hard launches and track use wear the friction disc and pressure plate. Used buyers are told to assume a clutch may be due unless records prove otherwise.
- What to do
- If it slips or smells burnt, ease off and have it inspected before the flywheel is damaged. Ask for clutch records when buying.
Soft clutch pedal from leaking slave cylinder
- What you'll notice
- The clutch pedal feels soft or is slow to come back up, and you may see a few drops of clear fluid under the transmission.
- Why it happens
- The slave cylinder inside the transmission bellhousing can leak. If ignored, the clutch can stop working entirely.
- What to do
- Get it looked at early, while the car still drives. Have a Viper-experienced shop or dealer confirm the leak source.
Water pump failure
- What you'll notice
- Coolant leaks from the front of the engine, a sweet smell, or the temperature gauge climbing.
- Why it happens
- The water pump on the last-generation Viper is reported to be prone to failure.
- What to do
- Watch for coolant drips and check the level often. Replace a leaking pump before the engine overheats.
Clunk or click from the rear driveline
- What you'll notice
- A clunk when getting on and off the throttle, or a single click or pop from the rear as the clutch is released.
- Why it happens
- RepairPal lists these as the most commonly reported Viper complaints. Some driveline clunk is considered normal on this car.
- What to do
- If the noise is new or getting louder, have the U-joints, differential and mounts checked.
Door hinges sag
- What you'll notice
- The door rides low, rubs or catches on closing, pops, or the weather seal is damaged and leaks water.
- Why it happens
- The door hinges on these cars can sag or deform over time.
- What to do
- Lift the open door gently to check for play. Have worn hinges adjusted or replaced before seals and paint are damaged.
Windows bind or hit the body
- What you'll notice
- A window is noisy or binds, or the glass touches the body when the door closes.
- Why it happens
- Window operation and door fit are known weak points carried over from earlier Vipers.
- What to do
- Run both windows fully up and down and close the doors slowly to check. Have the glass and door adjusted.
Repair prices for your 2016 Dodge Viper
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace clutch kit (OEM)
- Replace slave cylinder with clutch kit
- Replace worn U-joint
- Replace water pump
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger upper dash panel (recall 16V750000)No charge if your vehicle is included
- Replace driver airbag and clockspring (recall 16V736000)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…