Your 2005 Hummer H2problems, repair costs and recalls
What we've documented about the 2005 Hummer H2: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Hummer H2
20 documented issues apply to 2005, most serious first.
Wipers turn on by themselves or stop working
- What you'll notice
- The windshield wipers run on their own, will not shut off, work only now and then, or stop in the rain. The washer pump may also keep spraying until the reservoir is empty.
- Why it happens
- Water gets into the wiper motor and its control module at the base of the windshield, which corrupts the module. GM recalled some 2003 trucks for this, but owners of other years report the same thing.
- What to do
- Do not drive in rain or snow with wipers that may quit. Pulling the wiper fuse stops a runaway wiper temporarily. Ask a dealer whether your VIN is covered by a recall, then replace the wiper motor/module if not.
Blower motor wiring or resistor overheats
- What you'll notice
- A burning electrical smell, the fan working only on some speeds or cutting out, and in some reports melted plastic or smoke near the glove box.
- Why it happens
- The blower motor resistor and its wiring connector carry a lot of current and can overheat. Owners report melted connectors and harnesses on many H2 model years.
- What to do
- Turn the fan off and get it checked if you smell burning plastic. The resistor and its connector or pigtail should be replaced together.
Rusted brake lines burst (pedal sinks to the floor)
- What you'll notice
- The brake pedal suddenly goes soft or sinks to the floor, brake fluid leaks under the truck, or the brake warning light comes on.
- Why it happens
- The steel brake lines that run under the truck rust, especially where roads are salted, and eventually burst. Owners report sudden loss of braking with little warning.
- What to do
- If the pedal goes soft, stop driving and have the truck towed. On older H2s, have the brake lines inspected for heavy rust and replace them before they fail.
Hydro-boost brake accumulator can crack (recall)
- What you'll notice
- A heavier brake pedal and harder steering, or power steering fluid leaking near the brake booster.
- Why it happens
- The H2 uses the power steering pump to power its brakes (hydro-boost). The pressure reservoir on certain Bosch units can crack and come apart, letting fluid out and reducing brake and steering assist. GM recalled affected trucks.
- What to do
- Check your VIN for open recalls. If the brakes or steering suddenly feel heavy, stop safely and have it towed.
Front ball joint or steering knuckle failure
- What you'll notice
- Clunking from the front end, wandering steering, uneven tire wear, and in the worst cases a front wheel that collapses or comes off the truck.
- Why it happens
- The heavy H2 and its big tires put high loads on the front ball joints and steering knuckles. Owners report ball joints snapping and front wheels separating, sometimes at speed.
- What to do
- Have the ball joints and knuckles checked at every tire rotation, especially on lifted trucks or those with larger tires. Replace worn joints right away.
Airbag light on (airbag module or water damage)
- What you'll notice
- The airbag warning light comes on and stays on, sometimes with a service message or other modules acting up.
- Why it happens
- The airbag control module (SDM) can fail, and some owners trace it to rain water leaking into the cabin near the module.
- What to do
- The airbags may not work while the light is on. Have the codes read, fix any water leak first, then repair or replace the module.
Automatic transmission slipping or stuck in gear
- What you'll notice
- Slipping between 1st and 2nd, flaring engine revs, delayed engagement, or the transmission sticking in one gear.
- Why it happens
- The heavy-duty 4-speed automatic behind the 6.0L works hard moving a 6,400-pound truck, and its clutches wear out. Owners report slipping and stuck-in-gear problems.
- What to do
- Check the transmission fluid level and smell. Have it diagnosed before it gets worse; frequent towing or big tires make wear faster.
Frame and subframe rust
- What you'll notice
- Clicking when turning the steering wheel, heavy rust on the frame and underbody, or rusted-through brackets.
- Why it happens
- Road salt corrodes the H2’s frame and steel underbody parts. A dealer traced one owner’s clicking to a rusted subframe support.
- What to do
- Have the frame inspected, especially on trucks from snowy states. Treat rust early with an undercoating; severe rust needs welding repair.
Low oil pressure or failing lifters
- What you'll notice
- Low oil pressure warning, a ticking or tapping from the engine, or the gauge reading lower than normal.
- Why it happens
- Owners report collapsed or failed valve lifters and low oil pressure on high-mileage 6.0L engines.
- What to do
- Stop driving if the oil pressure light comes on. Check the oil level, then have a shop test oil pressure before more damage occurs.
Broken exhaust manifold bolts (ticking exhaust leak)
- What you'll notice
- A ticking or tapping noise from the engine bay that is loudest on a cold start, sometimes an exhaust smell inside or around the truck, and in some cases a check engine light.
- Why it happens
- The bolts holding the cast-iron exhaust manifolds to the 6.0L cylinder heads snap after years of heating and cooling. Once a bolt breaks, exhaust leaks past the gasket. Owners have reported this on many H2s, sometimes with damage to nearby parts.
- What to do
- Have the manifold area checked for broken bolts. A leak near the cabin can let exhaust fumes in, so do not ignore a strong exhaust smell. Broken bolts usually have to be drilled out, so pick a shop that has done this job before.
Speedometer and gauges stick or stop working
- What you'll notice
- The speedometer, tachometer or other gauges freeze, jump around, drop to zero at speed or stop working entirely. Warning lights may come on together or the cluster backlighting may fail.
- Why it happens
- Components inside the instrument cluster fail with age, especially the small motors that move the needles. Owners report it at many mileages on these years.
- What to do
- Use a phone GPS app to check your speed until it is fixed. A cluster rebuild service is usually much cheaper than a new dealer cluster, which also needs programming.
Air blows from the wrong vents or will not cool
- What you'll notice
- Air only comes out of the defrost vents, the A/C blows warm air, or you cannot change where the air comes out. You may hear a clicking behind the dash.
- Why it happens
- An electric mode or blend door actuator behind the dashboard fails. It is the small motor that moves the flaps that send air to each vent or mix hot and cold.
- What to do
- Have the HVAC system scanned to find which actuator has failed. It is usually a modest repair, and a battery change or disconnect can trigger a relearn.
Loose, wandering steering (worn pitman and idler arms)
- What you'll notice
- Steering feels vague or loose at highway speed, the truck wanders in its lane, or the steering wheel has play.
- Why it happens
- The pitman arm and idler arm that connect the steering box to the front wheels wear out under the H2’s weight. Owners often add a heavy-duty reinforcement kit when replacing them.
- What to do
- Have the steering linkage inspected and the front end aligned after any repair. Worn steering parts can also make braking feel unsettled.
Power steering leaks and hard steering
- What you'll notice
- Steering gets hard to turn, especially when parking, power steering fluid drips under the truck, or the pump whines.
- Why it happens
- Leaks at the power steering pump, cooler or hoses let fluid run low. Because the brakes share this fluid (hydro-boost), a leak can also affect braking. GM also recalled some power steering hoses built out of spec.
- What to do
- Check the power steering fluid level and look for leaks. Fix leaks quickly, since low fluid can damage the pump and affect brake assist. Ask a dealer about open hose recalls.
No-start from theft system or ignition switch
- What you'll notice
- The engine cranks but will not start or will not crank at all, sometimes with a security light, then starts after waiting several minutes. The key may stick in the ignition.
- Why it happens
- The Passlock theft-deterrent system and the ignition switch or lock cylinder can fail with wear, so the computer stops fuel or cranking.
- What to do
- Note whether the security light is on when it will not start. A shop can read the theft-system codes; the fix is usually an ignition switch, lock cylinder or Passlock sensor.
Sunroof drains clog and leak water inside
- What you'll notice
- Water drips onto the front floor or seats, the headliner gets wet, or the carpet smells musty after rain.
- Why it happens
- The drain tubes at the corners of the sunroof tray clog with debris, so rain water overflows into the cabin instead of draining out.
- What to do
- Have the sunroof drains cleared and tested. Dry the carpet promptly to prevent mold and damage to wiring under the floor.
Heated seats turn on by themselves or overheat
- What you'll notice
- A seat heater comes on by itself, will not turn off, or gets very hot; one owner found damaged wiring in the seat cushion.
- Why it happens
- The heated seat element or its control switch and module can fail.
- What to do
- Unplug or fuse off the seat heater until it is fixed if it overheats. Have the heater element and control switch checked.
ABS and traction control lights come on
- What you'll notice
- The ABS and traction control lights flicker on and off; in one case gauges, windows and locks lost power at the same time.
- Why it happens
- Faults in the ABS control module or wheel speed sensor wiring set warning lights. GM also recalled some trucks for reversed wheel speed sensor wires.
- What to do
- Have the ABS codes read. Normal braking still works, but ABS and traction control may be off.
Crankshaft sensor wiring breaks down
- What you'll notice
- The engine stalls or will not start, sometimes only now and then.
- Why it happens
- The wiring pigtail for the crankshaft position sensor becomes brittle from engine heat and shorts out.
- What to do
- Have the crank sensor and its wiring checked. Repairing the wiring and replacing the sensor is usually a modest job.
Front differential seal and transmission cooler line leaks
- What you'll notice
- Oil spots under the front of the truck or a small leak at the front differential or transmission cooler lines.
- Why it happens
- Seals on the front differential and fittings on the transmission cooler lines can seep, even on low-mile trucks.
- What to do
- Have the leak located and fixed before fluid levels drop, which can damage the differential or transmission.
Repair prices for your 2005 Hummer H2
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Extract broken manifold bolts and replace manifold gasket (one side)
- Remove instrument cluster, send out for rebuild, reinstall
- Replace windshield wiper motor and module assembly
- Replace HVAC mode/blend door actuator
- Replace blower motor resistor and connector pigtail
- Replace rusted brake lines and bleed the system
- Replace front lower ball joints or control arms (both sides)
- Replace pitman arm and idler arm, align front end
- Replace leaking power steering hose or cooler line
- Replace ignition switch or lock cylinder and relearn theft system
- Diagnose airbag system and replace airbag control module
- Clear and test sunroof drain tubes
- Rebuild or replace 4-speed automatic transmission
- Replace front differential seal or transmission cooler line
- Replace seat heater element or control module
- Diagnose ABS codes; replace wheel speed sensor or ABS module
- Repair rusted subframe support or frame section
- Replace lifters and related valvetrain parts (or engine)
- Replace crankshaft position sensor and repair wiring pigtail
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall: test hydro-boost unit and replace if it failsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…