Your 2007 Hummer H2problems, repair costs and recalls
What we've documented about the 2007 Hummer H2: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Hummer H2
11 documented issues apply to 2007, most serious first.
Blower motor wiring or resistor overheats
- What you'll notice
- A burning electrical smell, the fan working only on some speeds or cutting out, and in some reports melted plastic or smoke near the glove box.
- Why it happens
- The blower motor resistor and its wiring connector carry a lot of current and can overheat. Owners report melted connectors and harnesses on many H2 model years.
- What to do
- Turn the fan off and get it checked if you smell burning plastic. The resistor and its connector or pigtail should be replaced together.
Heated washer fluid system fire risk (recall)
- What you'll notice
- Washer fluid heater problems, an electrical burning smell, smoke from under the hood, or other electrical faults.
- Why it happens
- The heated windshield washer system had a circuit board and ground wire that could short and overheat. GM issued recalls, first adding a fused harness and later disabling the module, because it could start a fire.
- What to do
- Make sure the heated washer recalls are done on your VIN. Until then, stop using the heated washer feature and have it checked if you smell burning.
Airbag light on (airbag module or water damage)
- What you'll notice
- The airbag warning light comes on and stays on, sometimes with a service message or other modules acting up.
- Why it happens
- The airbag control module (SDM) can fail, and some owners trace it to rain water leaking into the cabin near the module.
- What to do
- The airbags may not work while the light is on. Have the codes read, fix any water leak first, then repair or replace the module.
Automatic transmission slipping or stuck in gear
- What you'll notice
- Slipping between 1st and 2nd, flaring engine revs, delayed engagement, or the transmission sticking in one gear.
- Why it happens
- The heavy-duty 4-speed automatic behind the 6.0L works hard moving a 6,400-pound truck, and its clutches wear out. Owners report slipping and stuck-in-gear problems.
- What to do
- Check the transmission fluid level and smell. Have it diagnosed before it gets worse; frequent towing or big tires make wear faster.
Frame and subframe rust
- What you'll notice
- Clicking when turning the steering wheel, heavy rust on the frame and underbody, or rusted-through brackets.
- Why it happens
- Road salt corrodes the H2’s frame and steel underbody parts. A dealer traced one owner’s clicking to a rusted subframe support.
- What to do
- Have the frame inspected, especially on trucks from snowy states. Treat rust early with an undercoating; severe rust needs welding repair.
Broken exhaust manifold bolts (ticking exhaust leak)
- What you'll notice
- A ticking or tapping noise from the engine bay that is loudest on a cold start, sometimes an exhaust smell inside or around the truck, and in some cases a check engine light.
- Why it happens
- The bolts holding the cast-iron exhaust manifolds to the 6.0L cylinder heads snap after years of heating and cooling. Once a bolt breaks, exhaust leaks past the gasket. Owners have reported this on many H2s, sometimes with damage to nearby parts.
- What to do
- Have the manifold area checked for broken bolts. A leak near the cabin can let exhaust fumes in, so do not ignore a strong exhaust smell. Broken bolts usually have to be drilled out, so pick a shop that has done this job before.
Air blows from the wrong vents or will not cool
- What you'll notice
- Air only comes out of the defrost vents, the A/C blows warm air, or you cannot change where the air comes out. You may hear a clicking behind the dash.
- Why it happens
- An electric mode or blend door actuator behind the dashboard fails. It is the small motor that moves the flaps that send air to each vent or mix hot and cold.
- What to do
- Have the HVAC system scanned to find which actuator has failed. It is usually a modest repair, and a battery change or disconnect can trigger a relearn.
Power window falls into door or stops working
- What you'll notice
- A window will not go up or down, makes a grinding noise, or drops down into the door.
- Why it happens
- The window regulator cable or motor in the door fails. Owners report rear windows dropping and getting stuck open.
- What to do
- Tape plastic over the opening to keep rain out until it is fixed. The regulator and motor are often replaced together.
Front wheel bearing hub failure
- What you'll notice
- A humming or growling noise that rises with speed, play in the wheel, or an ABS warning light.
- Why it happens
- The sealed front wheel bearing and hub assemblies wear out on this heavy truck. One owner had a dealer find bad front bearings after a driving problem.
- What to do
- Have the noise checked; a failing bearing can overheat and let the wheel wobble.
ABS and traction control lights come on
- What you'll notice
- The ABS and traction control lights flicker on and off; in one case gauges, windows and locks lost power at the same time.
- Why it happens
- Faults in the ABS control module or wheel speed sensor wiring set warning lights. GM also recalled some trucks for reversed wheel speed sensor wires.
- What to do
- Have the ABS codes read. Normal braking still works, but ABS and traction control may be off.
Front differential seal and transmission cooler line leaks
- What you'll notice
- Oil spots under the front of the truck or a small leak at the front differential or transmission cooler lines.
- Why it happens
- Seals on the front differential and fittings on the transmission cooler lines can seep, even on low-mile trucks.
- What to do
- Have the leak located and fixed before fluid levels drop, which can damage the differential or transmission.
Repair prices for your 2007 Hummer H2
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Extract broken manifold bolts and replace manifold gasket (one side)
- Replace HVAC mode/blend door actuator
- Replace blower motor resistor and connector pigtail
- Diagnose airbag system and replace airbag control module
- Rebuild or replace 4-speed automatic transmission
- Replace front differential seal or transmission cooler line
- Replace window motor and regulator assembly
- Replace front wheel bearing hub assembly (one side)
- Diagnose ABS codes; replace wheel speed sensor or ABS module
- Repair rusted subframe support or frame section
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall: install fused harness or disable heated washer moduleNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…