Your 2020 Jeep Gladiatorproblems, repair costs and recalls
What we've documented about the 2020 Jeep Gladiator: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2020 Jeep Gladiator
9 documented issues apply to 2020, most serious first.
Death wobble front-end shake
- What you'll notice
- After a bump at highway speed, the steering wheel and front end shake violently and keep shaking until you slow way down.
- Why it happens
- Like the Wrangler, the Gladiator uses a solid front axle that depends on tight steering and suspension joints. Loose track bar bolts or worn track bar, tie rod, drag link or ball joint parts can start a runaway shake. A worn steering damper can hide the problem but does not cause it.
- What to do
- Slow down steadily without jerking the wheel. Have the track bar bolts torqued and the track bar, tie rods, drag link and ball joints inspected and replaced as needed, then balance and align the tires.
Misfire and ticking from worn rocker arms or camshaft
- What you'll notice
- A check engine light (sometimes flashing) with misfire codes, rough running, loss of power on hills, and a ticking noise that gets worse over time.
- Why it happens
- On the 3.6L V6, a rocker arm roller can fail and wear a groove into a camshaft lobe, and lifters can go soft. Misfires from these and from worn plugs or coils are the second most common 2020 Gladiator complaint.
- What to do
- Have the misfire diagnosed beyond plugs and coils, including a check of the rockers and cam lobes. If the valvetrain is worn, the rockers and camshaft are normally replaced together. Ask about powertrain warranty coverage.
Manual clutch can overheat and break (recalls)
- What you'll notice
- A clutch temperature warning, a burning smell or smoke after slow off-road or stop-and-go driving, a soft pedal, or slipping and hard shifting.
- Why it happens
- The clutch pressure plate can overheat and crack, which can throw debris, start a fire or leave you without drive. Early recalls rerouted wiring and added software; recall 23V-116 replaces the clutch assembly.
- What to do
- Check your VIN for recalls 20V-124, 21V-028 and 23V-116. If you see the warning or smell burning, stop and let the clutch cool, and avoid long clutch slipping until it is repaired.
Instrument cluster can go blank (recall)
- What you'll notice
- The gauge cluster goes dark or flickers, gauges stop working, all warning lights come on at once, or turn signal indicators stop showing.
- Why it happens
- The instrument cluster can short internally and fail.
- What to do
- Check your VIN for recall 24V-652. The dealer replaces the cluster free. Drive carefully until then, since warnings may not show.
Rear driveshaft joint built without grease (recall)
- What you'll notice
- A vibration at 45-70 mph that gets worse over time. In the worst case the driveshaft breaks.
- Why it happens
- The joint at one end of the rear driveshaft on some early trucks was assembled without grease, so it can overheat, seize or fracture.
- What to do
- Check your VIN for recall 19V-636. The dealer replaces the driveshaft free. If it breaks, set the parking brake before leaving the truck.
Front seat belt may not hold in a crash (recall)
- What you'll notice
- No symptoms.
- Why it happens
- A front seat belt retractor might not control the occupant's forward movement after it locks in a crash.
- What to do
- Check your VIN for recall 20V-580. The dealer replaces the retractors free.
Wandering, loose steering at highway speeds (TSB)
- What you'll notice
- The truck drifts left or right and needs constant small corrections to stay in its lane, with play or a dead spot at center. Wind and trailers make it worse.
- Why it happens
- Wandering is the top 2020 Gladiator complaint, often in the first few thousand miles. Jeep's bulletin 08-074-20 covers replacing the steering gear and updating the electric-hydraulic power steering software.
- What to do
- Have the alignment checked and ask the dealer about bulletin 08-074-20. If the steering still feels loose afterward, go back, since some owners needed further work.
Backup camera image stays on after reverse (recall)
- What you'll notice
- The rear camera picture stays on the screen after you shift out of reverse.
- Why it happens
- A radio software error kept the image on longer than federal rules allow.
- What to do
- Check your VIN for recall 20V-191. The update is free at a dealer or over the air.
Rubicon sway bar disconnect stops working
- What you'll notice
- The sway bar disconnect light flashes and the front sway bar will not disconnect or reconnect.
- Why it happens
- Water and mud can corrode the electric actuator and its connector, and the bar can bind when it is under load. Owners filed a class action over failures.
- What to do
- Park on level ground and try again so the bar is not loaded. If it still fails, have the actuator and connector checked.
Repair prices for your 2020 Jeep Gladiator
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front track bar and re-torque steering joints
- Replace steering gear, update power steering software and align
- Replace rocker arms and camshaft
- Replace front disconnecting sway bar assembly
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace clutch assembly and update softwareNo charge if your vehicle is included
- Replace instrument clusterNo charge if your vehicle is included
- Replace rear driveshaftNo charge if your vehicle is included
- Replace front seat belt retractorsNo charge if your vehicle is included
- Update radio softwareNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…