Your 2002 Nissan Frontierproblems, repair costs and recalls
What we've documented about the 2002 Nissan Frontier: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2002 Nissan Frontier
6 documented issues apply to 2002, most serious first.
Distributor shaft seizing (stalls or will not start)
- What you'll notice
- The engine cuts out in traffic, runs rough, or cranks but will not start. It may restart after cooling down, then quit again.
- Why it happens
- First-generation trucks use a distributor, and its shaft bearing can rust and bind. As it drags, ignition timing and spark become erratic until the engine dies.
- What to do
- Do not rely on the truck until it is fixed, since it can stall in traffic. Have the ignition system checked and replace the distributor if the shaft is binding.
Lower steering shaft joint can corrode (recall)
- What you'll notice
- Steering may feel stiff or notchy, especially at full lock during slow turns or parking.
- Why it happens
- Road salt can rust the lower steering shaft joint. A badly corroded joint can crack and cause loss of steering control at low speed. Nissan recalled affected trucks.
- What to do
- Check your VIN for open recalls right away and have the shaft inspected. If the steering binds or feels unusual, do not drive it until it is checked.
Fuel pump wiring terminal can crack and corrode (recall)
- What you'll notice
- Long cranking, a stall at low speed or while idling, or the engine will not start at all.
- Why it happens
- The electrical terminal on the in-tank fuel pump can crack and corrode, which cuts power to the pump.
- What to do
- Have it checked before it strands you or stalls you in traffic; the pump assembly is replaced.
Water in the rear axle can ruin the wheel bearings (recall)
- What you'll notice
- A growl or hum from the back that changes with speed, or play felt at a rear wheel.
- Why it happens
- Water gets into the rear axle past the seal around the wheel speed sensor and rusts the bearings from the inside.
- What to do
- Have the rear bearings and the seal checked. Worn bearings get noisy first and can fail later.
Supercharged engine can drop into a low power mode (recall)
- What you'll notice
- The engine suddenly will not rev past a low limit and the truck feels very slow, often with a warning light.
- Why it happens
- The control system can enter a failsafe mode that caps engine speed on supercharged trucks.
- What to do
- It is not dangerous to shut off and restart, but have the control software updated so it does not strand you in traffic.
Cracked exhaust manifold (3.3L)
- What you'll notice
- A ticking or puffing sound from the engine bay, louder when cold, sometimes with an exhaust smell or a check engine light.
- Why it happens
- The manifold, most often on the right side, can crack or lose its studs after years of heating and cooling. Nissan published a service bulletin for this ticking noise.
- What to do
- Have the manifold inspected. It is not an emergency, but fix it before exhaust fumes start reaching the cab or the leak grows.
Repair prices for your 2002 Nissan Frontier
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace distributor assembly
- Replace cracked exhaust manifold and gaskets
- Replace lower steering column shaft and joint
- Replace in-tank fuel pump assembly
- Reseal sensor and replace rear wheel bearings
- Reprogram engine control module
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…