Home › Code lookup › P0323
Powertrain code · Ignition

P0323 Ignition/Distributor Engine Speed Input Circuit Intermittent

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine speed (RPM) signal from the distributor or ignition system keeps dropping in and out, which can make the engine cut out.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether the tachometer works while cranking
  2. Inspect wiring and connectors at the distributor or crank sensor
  3. Test the pickup sensor signal with a scope or meter

Signs you may notice

  • Check engine light on
  • Engine stalls, cuts out or won't start
  • Tachometer may jump around or drop to zero

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty crankshaft position or distributor pickup sensor
  • CommonBad ignition module or igniter
  • PossibleDamaged wiring or loose connector in the signal circuit
  • PossibleWorn distributor shaft bushings causing an erratic signal

Typical repair once the cause is confirmed

Usually a new crank or distributor pickup sensor, ignition module, or a wiring repair.

Walk through it step by step: Engine stalls while driving →

Common questions

What does P0323 mean?

The engine speed (RPM) signal from the distributor or ignition system keeps dropping in and out, which can make the engine cut out.

Can I drive with code P0323?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0323?

Common possibilities to test include: faulty crankshaft position or distributor pickup sensor; bad ignition module or igniter; damaged wiring or loose connector in the signal circuit; worn distributor shaft bushings causing an erratic signal. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.