Home › Code lookup › P0335
Powertrain code · Engine

P0335 Crankshaft Position Sensor "A" Circuit

How urgent? Otherwise: Get it checked in the next few days

What it means

The engine computer says there's a fault in the circuit for crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: Be cautious: a failing crank sensor can make the engine stall without warning, even in traffic, and it may not restart until it cools. If it has stalled or stumbles, keep trips short and avoid highways until it's fixed. If it won't start, have it towed.

What to test before replacing parts

Check the crank sensor signal with a scope or scan tool, inspect the wiring and connector for oil or damage, and check the sensor gap and tone ring before replacing the sensor.

  1. Check whether the tachometer moves while cranking
  2. Inspect the sensor's connector and wiring for oil, heat damage or chafing
  3. Test the sensor signal with a scope or meter before replacing it

Signs you may notice

  • Check engine light on
  • Engine stalls, often when warm, and may not restart until it cools
  • Cranks but won't start
  • Stumbling, misfiring or a jumpy tachometer

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed crankshaft position sensor
  • CommonDamaged wiring or loose, oil-soaked connector
  • PossibleDamaged or loose reluctor (tone) ring on the crank or flywheel
  • PossibleExcess gap between sensor and tone ring, or metal debris on the sensor tip
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Most often a new crankshaft position sensor; check the wiring first, and use a quality brand part.

Repair costInsufficient verified pricing for this vehicle and repair
Replace crankshaft position sensor. Prepare an itemized shop request.

Where it shows up

  • Nissan recalled crankshaft sensors on some early-2000s Altima and Sentra 2.5 models for stalling

Known on these vehicles

Walk through it step by step: Engine stalls while driving →

Common questions

What does P0335 mean?

The engine computer says there's a fault in the circuit for crankshaft position sensor A. This sensor tells the computer engine speed and piston position, so problems can cause stalling or a no-start.

Can I drive with code P0335?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: Be cautious: a failing crank sensor can make the engine stall without warning, even in traffic, and it may not restart until it cools. If it has stalled or stumbles, keep trips short and avoid highways until it's fixed. If it won't start, have it towed.

What causes P0335?

Common possibilities to test include: failed crankshaft position sensor; damaged wiring or loose, oil-soaked connector; damaged or loose reluctor (tone) ring on the crank or flywheel; excess gap between sensor and tone ring, or metal debris on the sensor tip. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.